Download the model file ► Deviation Firmware must be already installed onto the Devo 7E
- Connect Devo 7E to PC using the USB - MiniUSB cable
- Hold down the ENT button on the Devo 7E and power ON the Devo7E;
- On the PC using File Explorer browse to the Devo 7E's drive and "models" folder
- copy the new model1.ini file to this folder
(if model1.ini already is set up for a different drone than use another number, like model2.ini or model3.ini etc, don't use different file-names!)
- remove USB cable from Devo 7E
- power OFF/ON Devo 7E
- bind Devo 7E to Syma X5C
(Model Menu, Model setup, File Load, select "Syma XDC")
- if the HOLD switch is on 0 than the drone will fly normally, if the HOLD switch is set to 1 than when the right stick is moved fully to a direction, the drone will do a 360° flip
Thank you for your visit.
Plese take a moment to visit our special offers for today.
************************************************************
Over 450
Free E-book's
************************************************************
FREE PLR Articles for your content!
Just Spin a little bit , rewrite if you want , FREE to use!
************************************************************
No comments:
Post a Comment